Justin Amurao

Capilano Substation

• 60kv SF6 circuit breaker and bus assembly working alongside BB/HITACHI, inspecting connections, lifting breakers and bus into place with crane
• 25kv GIS switch gear install and terminations, pulled, dressed and landed cables into gear through gland plates, read prints and terminated cables into proper locations, stripped hydro cable and performed hydro terminations for ground, moved switch gear into place
• Installed copper bus on 25kv switch gear, worked closely with Hyundai, applying grease, preparing surfaces with alcohol, inspecting connections for dust, bolting and torquing to spec
• Wired 25kv switch gear PNC panels, moved and bolted panels into place, pulled cables and dressed cables to panels, read prints and terminated all cables into correct locations
• Installed and built battery rack, read engineering spec, prints and diagrams to build battery rack, lifted batteries with proper procedure safely to rack
• Installed 38 stacking reactor bays, moved and stacked reactors into place with crane, grounded reactors, built aluminum wall bus, installed nema pad connections, torqued everything to spec once all completed

Mainwaring Substation

• Moved, stacked and installed 48 reactor bays (3 reactors each bay), gantry crane used for critical lift of reactors, grounded reactor bays, installed aluminum wall bus
• Installed PNC for 12kv switch gear, moved PNC panels into place, drilled and bolted down, pulled cables from GIS gear to PNC panels, read prints and cross checked with pull schedule and various other drawings to solve deficiencies with wiring in PNCs, worked closely with CPC tech to solve any problems with panels
• Wired 12kv GIS gear, pulled cables, stripped and terminated cables into gear referencing prints and other drawings to terminate and work through issues

Sperling Substation

• Installed contingency bus, drilled aluminum plates, drilled anchors for bus
• Pulled cable for new breakers, after cables were pulled stripped and terminated cables in PNC panels

Bentall 6

• Installed 12kv switch gear for main electrical room, installed strand bus in gear, pull and wired gear,
• General rough in, pulled cables, installed boxes, piping, laying out

The Paramount

• General rough in, pot lights, pulling bx, bending pipe
• Managed lighting control and power system for entire floor, pulled cat 6 cables for the whole floor, troubled shooted power and lighting systems for the floor, working closely with programmer to diagnose and fix problems