Dawson Dombrowsky

During my time at staal irrigation I participated in team projects, demonstrating an ability to work collaboratively and effectively through my achievements below during

• Daily average of roughly 600-700 ft of trenching for buried service wire (9 inches deep and about 4 inches wide) as a 2 man crew. (includes backfilling, clean up work, clearing any obstacles and pulling fiber optic cable through conduit)
• Excellent attention to detail leaving jobsites without evidence of digging
• Assisted with vacuum truck operation
• Contracted by CPKC after tbaytel pulled our contract due to cost working for about 3-4 months (total) on a tie gang, rail crew and later a utility crew.

During my time at NWC i worked along side some great carpenters achieving the following points

• Used measuring tools such as gauges and tape measure to identify conforming parts during production.
• Carefully cut PVC and steel according to specifications, which in turn reduced wasteful spending.
• Moved and cleared debris from work sites to dispose of in designated areas.
• Loaded and unloaded materials and equipment onto and off construction sites.
• Increased productivity with effective communication and collaboration among team members.
• Collaborated with team members to carry out efficient work with optimal safety and achieve timetables.
• Demonstrated strong work ethic, completing physically demanding tasks under varying conditions.

During my time with Tramin limited i learnt and completed the following points.

• Constructed barbed wire fence with efficient and effective teamwork
• Worked at multiple mine sites such as:

New gold rainy river

consisting mainly of clean up under conveyors in the mill and crusher tunnel as well as the floor of the mill utilizing hoses, shovels and skidsteers to remove crusher dust and muck

Evolution balmertown mill

we were contracted to assist in the removal and replacement of their rod mill liners, during this i made use of a range of tools such as impact guns, giant air pressure hammer gun to knock the bolts out of the rod mill liners as i was assisting from the outside

i also was assisting in rigging up all the roughly 700lb liners for the overhead crane to move around the whole project went smoothly and i believe we broke a record.