Byron Hrdlitchka

• Worked Shafts start to finish. I Installed "Shaft Mods" which consisted of several runs of S/A R/A and Exhaust runs spanning 40-50 linear feet of duct fastened to an angle iron frame. A crane picked these "mods" up and my responsibility was to communicate with the crane operator and line up the shaft mod with the shaft opening, drop the shaft mod to the right elevation, then run C-Channel across the opening adjacent to the shaft mod, bolt it together, then weld the C-channel to the "In-bed" on the outside of the shaft opening.(Stick Welding
• Grease Duct - I Measured , Ordered And installed a majority of the grease duct on site. (Mig Welding)
• Stainless - Fabricated alot of onsite fittings, installed square, and round stainless and have done countless position welds.(TIG welding)
• Rigging and Hoisting - Installed fans weighing up to a 1/2 ton.

Installed a Plennum in the parkade that was 30' long by 6' wide by 6' tall using four 2 ton chainfalls with 5/8s wedge anchors and eyebolts

• Fabricated and installed custom sheet metal components for various projects.
• Operated hand tools and machinery to shape, cut, and assemble metal sheets.
• Interpreted blueprints and technical drawings to ensure accurate measurements and specifications.
• Maintained equipment and tools for optimal performance and safety compliance.
• Conducted quality control inspections on finished products to meet industry standards.
• Welded Elbows & Pipe together Amongst Many other projects that required welding like handrails ect