Bryant Gil-Haro

Coordinate and expedited maintenance actions to ensure timely repair and return of assets to mission ready status.

• Serve as a primary liaison between maintenance and supervision to prioritize workload and resolve delays.
• Verify technical data, forms, and documentation are accurate and in compliance to costumer standards.
• Assisted in scheduled maintenance tasks and allocating manpower based on mission requirements.
• Communicated real time updates to leadership.
• Ensured safety, quality, and procedural compliance across all maintenance and operational compliance.
• Replaced damaged, missing, or defective parts with new and refurbished components.
• LO Mechanic I maintain and or repair coatings under proper procedures and specs/ blue prints.
• Help other specialties where needed to assist with schedule needs.
• Paint.
• Properly setting up spray guns.
• Coordinating proper masking and mapping of areas to be sprayed.
• Identifying correct materials to be applied.
• Remove and Apply Low Observable materials to proper specifications.
• Applique.
• Gap Fillers.
• Paste adhesives.
• MagRAM.

• As a Composite Tech I am responsible for overseeing proper execution of Standard procedures for product completion.
• I buy off to verify that the part is completed to proper specifications that had been identified in the blueprint provided by engineering.
• Laying up parts with pre-impregnated materials.
• Sealing and releasing tools for parts or molds.
• Laying up simple to complex parts under proper steps and procedures.
• Proper handling, beveling, preparation, and cleaning of core.
• Using debulk bags and materials for compaction with in layers of materials.
• Final bagging with proper steps and materials with careful handling.
• Running ovens and autoclave oven with proper cure cycles.
• Un-bagging and proper marking trim and finish of parts for final buy-offs.
• Applying different techniques that were acquired over various programs, Model 401XP, Model 401XD, Model 400, and the Stratolaunch program.
• Wet Lay-up.
• Sealing and releasing tools for parts and molds.
• Working with 2 part epoxy systems to wet out of carbon fiber or glass materials.
• Proper handling, beveling, and cleaning of foam, honeycomb core, and aluminum core.
• Working on proper pot life.
• Final bagging under proper steps and procedures.
• Contact lay-ups.
• Resin infusion procedures for parts or molds.
• Applying different techniques that were acquired over various programs, Model 401XP, Model 401XD, Model 400, Mocean, Water wings, Various payloads for the Proteus Test bed, Stratolaunch program along with other Scaled Composites proprietary programs.
• Assemble structures.
• Trim and fit parts.
• Proper bonding of parts and structures with procedures.
• Proper inspections, cleaning, and F.O.D awareness before bay close out such as fuel bays, flight controls.
• Blind flanges and close out procedures.
• Drill holes from pilot to final sizes with step up procedures.
• Grip lengths for proper fastener install.
• Install proper hardware and fasteners.
• Bond nutplates.
• Structural repairs.
• Flight control cable pulley installation.
• Liquid Shimming.
• FIP Seal.
• Click bond adhesive.

• Wet sanding and buffing scratches in vehicles daily.
• Paint restoration.
• Paint oxidation, swirl removal, and polishing.
• Shampooing interior.
• Interior stain removal.
• Maintenance and troubleshooting of the carwash machine.
• Performed comprehensive exterior and interior detailing to enhance vehicle appearance and value.
• Maintained inventory of cleaning supplies and tools, ensuring availability for efficient operations.
• Trained new staff on best practices in car detailing techniques and customer service standards.
• Resolved customer concerns regarding detailing services, enhancing overall satisfaction and retention rates.
• Delivered consistent results while working independently on various makes/models/styles of cars within tight deadlines.